On the Ethernet Devices tab
or iSCSI Devices tab, select the iSCSI-enabled
multifunction adapter. Click the adapter or team to select or
deselect it. When an adapter or team is selected, it is
highlighted.
Click Properties.
Select the Information tab. Adapter information is
read only and includes the following:
Current MAC
Address. The current MAC address for the iSCSI
device.
iSCSI Driver
Name. The name of the driver for the iSCSI device.
iSCSI Driver
Version. The version of the driver for the iSCSI
device.
Default
Gateway. The default route for the iSCSI device.
Subnet
Mask. The subnet mask (dotted decimal) for the iSCSI
device.
iSCSI VLAN
Id. The identification number (if any) for the virtual
iSCSI VLAN device.
iSCSI Packet
Priority. The packet priority for the iSCSI device.
Page File
Created. Indicates whether or not the Windows page file
was created on an iSCSI drive that is attached to the adapter. The
values are Yes and No.
DHCP (Dynamic
Host Configuration Protocol). Enabled indicates that DHCP
is used to acquire IP configuration; Disabled indicates that the
statically configured IP configuration is used.
IPv4
Address. The IPv4 address (dotted decimal) for the iSCSI
device.
IPv6
Address. The IPv6 address for the iSCSI device.
