 Important: |
|---|
| This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
Building and installing your target system requires the following procedures. (For a specific procedure, click the appropriate hyperlink.)
- Set the target media and repository path, and then verify those settings every time you build a configuration.
- Check the dependencies.
- Resolve any existing dependencies or conflicts.
- Build your configuration.
- Install directly to the target system, to a temporary location
on your hard disk, or on media to transfer to your embedded system
later.
Note Target paths are global for each copy of Target Designer.
In the All Nodes pane, a configuration is represented by a folder and computer icon.
See Also
Using Target Designer to Design an Embedded System