Network commands

The network subsystems are located at:

/map1/enetport1
/map1/dhcpendpt1
/map1/dnsendpt1
/map1/gateway1
/map1/dnsserver1
/map1/dnsserver2
/map1/dnsserver3
/map1/dhcpserver1
/map1/settings1
/map1/vlan1

Properties, Targets, and Verbs:

dhcpendpt1
Properties
- EnabledState
- OtherTypeDescription
dnsendpt1
Properties
- EnabledState
- HostName
- DomainName
- OtherTypeDescription
gateway1
Properties
- AccessInfo
- AccessContext
dnsserver1
- Properties
  - AccessInfo
  - AccessContext
- Verbs
  - cd
  - version
  - exit
  - show
  - set
dnsserver2
Properties
- AccessInfo
- AccessContext
dnsserver3
Properties
- AccessInfo
- AccessContext
dhcpserver1
Properties
- AccessInfo
- AccessContext
settings1
- Targets
  DNSSettings1
  
  Properties
  - DNSServerAddress
  - RegisterThisConnection
  - DomainName
  - DHCPOptionToUse
  WINSSettingData1
  
  Properties
  - WINSServerAddress
  - RegisterThisConnection
  - DHCPOptionToUse
- Verbs
  - cd
  - version
  - exit
  - show
StaticIPSettings1
Properties
- oemhp_SRoute1Address
- oemhp_Gateway1Address
- oemhp_SRoute2Address
- oemhp_Gateway2Address
- oemhp_SRoute3Address
- oemhp_Gateway3Address
- DHCPOptionToUse

Examples

set /map1/enetport1 speed=100

set /map1/enetport1/lanendpt1 ipv4address=192.168.0.13 subnetmask=255.255.252

You can specify one or more properties on the command line. If multiple properties are given on the same command line, they must to be separated by a space.

iLO 3 is reset after network settings have been applied.