User commands

User commands enable you to view and modify user settings. User settings are located at /map1/accounts1.

Targets

All local users are valid targets. For example, if there are three local users with the login names Administrator, admin, and test, then valid targets would be:

Administrator
admin
test

Properties

Property	Access	Description
`username`	read/write	Corresponds to the iLO 3 login name.
`password`	read/write	Corresponds to the password for the current user.
`name`	read/write	Displays the name of the user. If a name is not specified, the parameter uses the same value as the login name (username). This value corresponds to the iLO 3 user name property.
`group`	read/write	Specifies the privilege level. The valid values are as follows: admin config oemhp_power oemhp_rc oemhp_vm If a group is not specified, no privileges are assigned to the user.

Examples

The current path is /map1/accounts1.

create username=lname1 password=password
In the example, username corresponds to the login name.
set lname1 username=lname2 password=password1 name=name2 group=admin,configure,oemhp_power,oemhp_vm,oemhp_rc
In the example, lname1 is the login name of the user.