You can specify default values for many of the fields in the dialog boxes that you fill out when you add computers to a server. This is useful if you are adding many computers with similar characteristics. How to...
Field |
Description |
Display name |
The name that is displayed in Command Center. The name must be unique on this server. |
ID |
The unique identifier of the computer. Cannot be edited after the computer has been added to Symantec LiveState Delivery. Use a minimum of three and a maximum of eight characters with the following limitations. Valid Characters
Invalid
Characters |
Description |
A description of the computer. |
Host name |
This name will be displayed as the Computer Name in the Control Panel Network properties dialog box. Use a maximum of 32 alphanumeric characters, including upper and lower case letters, numbers, dashes (-). and underscores (_). |
Hardware address |
The hardware address (MAC address) of the computer’s NIC. Note: If this is a Cooperative Mode computer with no NIC that is intended to be used solely as a dial-up mobile computer, you can type any 12 digits (for example, 111111111111) in the Hardware address field.
|
IP address |
The computer's IP address on BOOTP. If you use DHCP, this field is disabled. |
Cooperative mode |
Sets the computer type. After the computer is added to Symantec LiveState Delivery, this checkbox cannot be edited. Unchecked – Adds the computer as a Consistent Mode computer. (default) Checked – Adds the computer as a Cooperative Mode computer. |
See Also...
Computer Properties Dialog Box - Boot Security Tab for a Single Computer