 Important: |
|---|
| This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
Before beginning your build, you must check dependencies and then resolve any dependencies or conflicts between components in your configuration.
To check for dependencies or conflicts
- In the All Nodes pane, select the appropriate configuration.
- On the toolbar, click the
Check Dependenciesbutton:
- If conflicts exist or components are missing, record the message, and then add or remove components as needed.
- Repeat steps 1-3 until a message confirms that your
configuration has all the required components.
Note Target Designer might take a few minutes to check for dependencies and conflicts.
See Also
CapabilityDependencies Section
CapabilityComponentDependencies Section
ComponentCapabilityDependencies Section
To add a component to a configuration
To remove a component selection