 Important: |
|---|
| This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
A version of this page is also available for
4/8/2010
A cellular telephony service provider (TSP) can use the RIL to make inbound and outbound voice calls, as well as Remote Access Service (RAS) calls. The following section provides examples of the most typical call scenarios.
 Note: |
|---|
| The topics in this section contain references to Telephony API (TAPI) functions. For more information about these functions, see "TAPI Reference" at TAPI Reference. |
In This Section
- RIL Outgoing Voice Call Process
-
Describes steps required to make an outbound voice call.
- RIL Incoming Voice Call Receiving Process
-
Describes steps required to make an inbound voice call.
- RIL Voice Call Disconnecting Process
-
Describes steps required to hang up a RIL voice call or to use remote disconnect.
- Making a RAS Call by Using RIL
-
Describes steps required to use RIL when making a RAS call.
Related Sections
- Radio Interface Layer
-
Describes the Radio Interface Layer (RIL) that handles the communication between the CellCore system software and the radio hardware.
- RIL Application Development
-
Provides conceptual information about RIL itself and RIL application development scenarios.
Requirements
| Windows Embedded CE | Windows Embedded CE 6.0 and later |