t_getprotaddr()

NAME

t_getprotaddr - get the protocol addresses

SYNOPSIS

#include <xti.h>

int t_getprotaddr(
	int fd,
	struct t_bind *boundaddr,
	struct t_bind *peeraddr)

DESCRIPTION

The following table describes the parameters for t_getprotaddr(3):

Parameters Before call After call
fd x /
boundaddr->addr.maxlen x =
boundaddr->addr.len / x
boundaddr->addr.buf ? (?)
boundaddr->qlen = =
peeraddr->addr.maxlen x =
peeraddr->addr.len / x
peeraddr->addr.buf ? (?)
peeraddr->qlen = =

The t_getprotaddr(3) function returns local and remote protocol addresses currently associated with the transport endpoint specified by fd. In boundaddr and peeraddr the user specifies maxlen, which is the maximum size (in bytes) of the address buffer, and buf which points to the buffer where the address is to be placed. On return, the buf field of boundaddr points to the address, if any, currently bound to fd, and the len field specifies the length of the address. If the transport endpoint is in the T_UNBND state, zero is returned in the len field of boundaddr. The buf field of peeraddr points to the address, if any, currently connected to fd, and the len field specifies the length of the address. If the transport endpoint is not in the T_DATAXFER, T_INREL, T_OUTCON or T_OUTREL states, zero is returned in the len field of peeraddr. If the maxlen field of boundaddr or peeraddr is set to zero, no address is returned.

VALID STATES

ALL - apart from T_UNINIT

ERRORS

On failure, t_errno is set to one of the following:

[TBADF]
The specified file descriptor does not refer to a transport endpoint.
[TBUFOVFLW]
The number of bytes allocated for an incoming argument (maxlen) is greater than 0 but not sufficient to store the value of that argument.
[TPROTO]
This error indicates that a communication problem has been detected between XTI and the transport provider for which there is no other suitable XTI error (t_errno).
[TSYSERR]
A system error has occurred during execution of this function.

RETURN VALUE

Upon successful completion, a value of zero is returned. Otherwise, a value of -1 is returned and t_errno is set to indicate the error.

SEE ALSO

t_bind(3)