R-Studio Agent |
R-Studio Agent should be installed on a network computer to enable R-Studio access to its drives. R-Studio Agent should be registered. If, due to file system crash, the network computer where you are going to recover your data cannot start, you may use R-Studio Agent Emergency to start the computer. Attention Windows NT/2000/XP/2003/Vista/2008/7 users: R-Studio Agent should be installed under an administrator account. When installed, R-Studio Agent starts automatically and runs as a service. To configure it, R-Studio Agent should be started again manually. The following switches are available:
Started without a switch, R-Studio Agent runs as a GUI application and its icon appears on the taskbar tray. In this mode, it can be configured and its log may be viewed. Simply connect to the remote computer providing a desired password for R-Studio Agent in the Connect to Remote Computer dialog box. R-Studio checks if there is R-Studio Agent running on this computer. If not, a Can't connect... message will appear. Click the Yes button, and R-Studio will remotely install R-Studio Agent. Attention Windows NT/2000/XP/2003/Vista/2008/7 users: R-Studio Agent may be remotely installed over a network from a computer running Windows NT/2000/XP/2003/Vista/2008/7 to another computer running Windows NT/2000/XP/2003/Vista/2008/7. To do so, you must have administrator accounts on both computers. To access the R-Studio Agent main panel,
To configure R-Studio Agent,
|