|
Request ID
|
A system-assigned number that identifies the request.
|
Note:
|
An asterisk indicates a pending action.
|
|
|
Host Name
|
The name of the device host that has the pending
request.
|
|
Recorded Media ID
|
Media ID of the volume. It should match the media ID that is
stored in the EMM database. The ID consists of up to six
alphanumeric characters that are recorded at the beginning of the
volume to identify the volume.
A volume with a recorded media ID is a labeled volume. Unlabeled
volumes do not have recorded media IDs.
The recorded media ID should be the same as the external media
ID.
|
|
External Media ID
|
External media ID of the requested volume. This ID consists of
up to six alphanumeric characters and is usually written on an
external label on the volume. The external media ID is used to
identify the volume.
|
|
Density
|
Density of the requested volume. Mount the volume on a drive
that supports the required density. DLT is the default density.
To find a drive of the correct type, view the Type column in the drive status list. Note that
for some densities, the mapping to the drive type is not
identical.
The following are the valid densities:
-
4MM (4mm cartridge)
-
8MM (8mm cartridge)
-
8MM2 (8mm cartridge 2)
-
8MM3 (8mm cartridge 3)
-
DLT (DLT cartridge)
-
DLT2 (DLT cartridge 2)
-
DLT3 (DLT cartridge 3)
-
DTF (DTF cartridge)
-
HCART (1/2-inch cartridge)
-
HCART2 (1/2-inch cartridge 2)
-
HCART3 (1/2-inch cartridge 3)
-
QSCSI (1/4-inch cartridge)
|
|
Mode
|
Specifies whether the volume should be
write-enabled, as follows:
-
Write, you must write-enable the volume.
-
Read, you do not need to write-enable the volume unless
specified by site policy.
To write-enable a cartridge volume, move the tab off the safe
position.
|
|
Time
|
Time of day the user made the request for access.
|
|
Barcode
|
Alphanumeric representation of the bar code label on the
requested volume.
|
|
Volume Group
|
Volume group to which this volume belongs. A volume group
defines the volume by location and is a logical group of volumes
that are at the same physical location.
|
|
Media Description
|
Describes the media in 25 or less alphanumeric characters. You
create the description when you configure volumes.
|
