After you have created an operation file, you can run it in any of the following ways:
At the EVSVR> prompt, type load and then select the operation file that you want to load.
In the EVSVR Operations dialog box, click . EVSVR closes the EVSVR Operations dialog box and loads the currently saved operation file, ready to run.
At the MS-DOS command prompt >, type the following command:
where operation_file_path is the full path to the operation file. If the path contains spaces, enclose it in quotation marks. For example:
evsvr -r "C:\myfolder\operation files\op1.xml"
This command line is equivalent to a load command at the EVSVR> prompt, followed by a start command and, when processing has stopped, an exit command. You can use this command line in batch commands, if required.
Some operations may take a considerable time to complete, depending on factors such as the size of the data set, the date range, and the type of operation. You can use the stop, pause, resume, and restart commands to control a running operation, if required. Unless processing is interrupted, EVSVR continues processing until it has finished the operation.