Step 1

Decide where to install Enterprise Vault Reporting.

See Where and when to install Enterprise Vault Reporting.

Step 2

Satisfy the prerequisites for Enterprise Vault Reporting.

See Prerequisites for Enterprise Vault Reporting.

Step 3

Enable Enterprise Vault monitoring and auditing, if you want to use the reports that rely on these features.

You can perform this step at any time. However, the reports that rely on monitoring or auditing contain no data until the relevant feature is enabled and has gathered the relevant data.

See Enterprise Vault reports that require monitoring or auditing to be enabled.

Step 4

Configure FSA Reporting, if required.

Configure FSA Reporting at this point if possible. However, you can configure FSA Reporting later if necessary.

The reports are not available until you have performed steps 1 to 7 in this table.

See Configuring FSA Reporting.

Step 5

Perform the preinstallation steps for Enterprise Vault Reporting.

See Preparing for the installation of Enterprise Vault Reporting.

Step 6

Install the Enterprise Vault Reporting component.

See Installing the Enterprise Vault Reporting component.

Step 7

Run the Reporting Configuration utility to configure Enterprise Vault Reporting and to deploy the reports.

Do not perform this step until you have run the Enterprise Vault Configuration wizard on at least one computer in the site on which Enterprise Vault services are installed.

See Configuring Enterprise Vault Reporting.

Step 8

Check that the configuration was successful and that you can access the reports.

See Checking that the configuration of Enterprise Vault Reporting was successful.

Step 9

Remember to assign suitable administrator roles to any additional user accounts that require access to the reports.

See Administrator roles that provide access to Enterprise Vault Reporting's reports.