Vault Store Partition Properties: Rollover

Use this page to set the criteria by which Enterprise Vault rolls over from this partition to another, ready partition. You can configure partitions to roll over based on the free space or used space in the partition, or according to time criteria.

Partition Rollover. Choose from the following options:

Note:

On each physical disk, you should not attempt to configure more than one partition to roll over based on volume. This recommendation does not apply when your vault store partitions reside on separate volumes that are mounted on a single physical disk.

Volume. If you chose either Enabled based on volume or Enabled based on time or volume, you can make appropriate settings under Volume to trigger partition rollover according to the remaining free space on partition's host volume.

Set one of the following criteria to trigger rollover:

Time. If you chose either Enabled based on time or Enabled based on time or volume, you can make appropriate settings under Time to trigger partition rollover.

Set one of the following criteria to trigger rollover: