PCI Hot
Plug. If any member of a team is replaced, either by Hot
Plugging or by powering down the server, the team's MAC Address
should be reset using the NCU. To reset the MAC Address: from the
Ethernet Devices tab, select the team, click
Properties, and select the Team Settings tab. Click Restore Default, close the Team Properties
window, and then save the changes to the team by clicking
OK on the Ethernet Devices
tab to exit the NCU. PCI Hot plug is not supported in the NCU
on systems using Windows Server 2008 or Windows Server 2008
x64.
Ports in the
Team Configuration Should Match Switch Configuration.
Refer to the documentation that comes with your Switch-assisted
Load Balancing-capable switch for configuration information. After
your switch is properly set up, you can configure the adapters in
the server with the NCU.
Switchovers on
Adapters. If you experience network connectivity problems
when a switchover occurs on a team, verify that the secondary
adapters are on the same Layer 2 (Broadcast) network as the primary
adapter.
