Configuring the ESM data collector

You must configure the ESM data collector before you use the ESM data collector on a computer where Data Processing Service (DPS) is installed. The ESM data collector must be associated with one or more ESM managers.

Before you configure the ESM data collector, you must provide the details about the ESM components that the data collector is configured to communicate with. At any point of time after you configure the ESM data collector, you can re-configure the settings to make changes to the data collector.

You can configure the ESM Data Collector components from the Component Settings dialog box. Do the following to launch the Component Settings dialog box from the System Topology > Map View:

Do the following to launch the Component Settings dialog box from the System Topology > Grid View:

See Modifying the settings of a component .

The ESM-specific configuration options are available for a DPS only if the following parameters are fulfilled:

See Configuring the basic Data Processing Service settings.

ESM data collector configuration involves the following steps:

More Information

Configuring the ESM manager settings

Configuring the ESM general settings