HP Operations Manager for Windows

Installing the HP SiteScope Adapter


Full implementation of the HP SiteScope Adapter requires the following steps:

  1. Install the HP SiteScope Adapter on the HPOM management server.
  2. Deploy the HP SiteScope Adapter to managed nodes.
  3. Configure HP SiteScope to use the SendOVO script alerts.

The HP SiteScope Adapter is installed using an installation wizard that guides you through the procedure and prompts for information you must specify. Install the HP SiteScope Adapter only after the HPOM installation is complete.

Read the instructions before you begin so that you are familiar with the information you must supply during installation.

To install the HP SiteScope Adapter

  1. To start the installation process, select:

    Start All Programs HP HP Operations Manager SiteScope Adapter

    The Welcome page opens.

  2. Click Next to go to the License Agreement page.
  3. Read the license agreement statement and click I accept the terms in the license agreement.
    Then click Next to continue.
  4. In the Destination Folder page, click Next.
  5. In the Ready to Install the Program page, click Install to begin the installation.
  6. When the Installer Completed page opens, click Finish to close the wizard.

Following successful installation of the HP SiteScope Adapter on the HPOM management server system, you will see a SiteScope policy group in the Policy groups folder.

To determine the HP SiteScope version

After installation, it may be necessary to determine the version of HP SiteScope Adapter installed on the HPOM server for support, patch installation, or other reasons.

  1. Log on with Administrator capability.
  2. Run the Control Panel.
  3. Select Add or Remove Programs.
  4. Click HPOM SiteScope Adapter.
  5. Click Click here for support information.

Related Topics: