You can enter a numerical value for this option
to specify the size of the data stripes (in kilobytes), or you can
leave this option blank and allow ACU to use a default value.
The valid stripe size values depend on the RAID
level.
For RAID 0, RAID 1, or RAID 1+0 arrays, you
can enter any of the stripe size values listed in the sample
script.
For RAID 5 arrays, the maximum stripe size
in most cases is 256 KB, but old controller models are often
limited to 64 KB.
For RAID 6 arrays, the maximum stripe size
is either 64 KB or 256 KB, depending on the controller.
The default stripe size value depends on the
action mode.
In Configure action mode, the default value
is determined by the RAID level that you specified earlier in the
script. (In some cases, it also depends on the ACU version, the
controller model, and the controller firmware version).
For RAID 0, RAID 1, or RAID 1+0, the
default value is 128 KB.
For RAID 5, the default value is usually 64
KB, but on some controller models it is 16 KB or 128 KB.
For RAID 6, the default value is usually 16
KB, but on some controller models it is 64 KB or 128 KB.
In Reconfigure action mode, the default
value for this option is the stripe size that is already configured
for the logical drive. If you enter a value that is different from
the existing stripe size, ACU attempts to migrate the logical drive
to the stripe size that you specify. (If you intend to migrate the
logical drive, back up all data before starting the migration
procedure.)
500 Internal Server Error
Internal Server Error
The server encountered an internal error or
misconfiguration and was unable to complete
your request.
Please contact the server administrator at
webmaster@systemmanager.forsenergy.ru to inform them of the time this error occurred,
and the actions you performed just before this error.
More information about this error may be available
in the server error log.
Additionally, a 500 Internal Server Error
error was encountered while trying to use an ErrorDocument to handle the request.