WARNING: Only authorized technicians trained by
HP should attempt to repair this equipment. All troubleshooting and
repair procedures are detailed to allow only
subassembly/module-level repair. Because of the complexity of the
individual boards and subassemblies, no one should attempt to make
repairs at the component level or to make modifications to any
printed wiring board. Improper repairs can create a safety
hazard.
WARNING: To reduce the risk of personal injury or
damage to the equipment, be sure that:
The leveling
feet are extended to the floor.
The full
weight of the rack rests on the leveling feet.
The
stabilizing feet are attached to the rack if it is a single-rack
installation.
The racks are
coupled together in multiple-rack installations.
Only one
component is extended at a time. A rack may become unstable if more
than one component is extended for any reason.
WARNING:
To reduce the risk of electric shock or damage to the
equipment:
Do not disable
the power cord grounding plug. The grounding plug is an important
safety feature.
Plug the power
cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
Unplug the
power cord from the power supply to disconnect power to the
equipment.
Do not route
the power cord where it can be walked on or pinched by items placed
against it. Pay particular attention to the plug, electrical
outlet, and the point where the cord extends from the
server.
20.41 - 27.22 kg
47.18 - 60.0 lb
WARNING: To reduce the risk of personal
injury or damage to the equipment:
Observe local occupation health
and safety requirements and guidelines for manual handling.
Obtain adequate assistance to
lift and stabilize the chassis during installation or removal.
The server is unstable when not
fastened to the rails.
When mounting the server in a
rack, remove the power supplies and any other removable module to
reduce the overall weight of the product.
CAUTION: To properly ventilate the
system, you must provide at least 7.6 cm (3.0 in) of clearance at
the front and back of the server.
CAUTION: The server is designed to be
electrically grounded (earthed). To ensure proper operation, plug
the AC power cord into a properly grounded AC outlet only.
WARNING: Only authorized technicians trained by
HP should attempt to repair this equipment. All troubleshooting and
repair procedures are detailed to allow only
subassembly/module-level repair. Because of the complexity of the
individual boards and subassemblies, no one should attempt to make
repairs at the component level or to make modifications to any
printed wiring board. Improper repairs can create a safety
hazard.
CAUTION: To properly ventilate the
system, you must provide at least 7.6 cm (3.0 in) of clearance at
the front and back of the server.
