Microsoft Windows NT Embedded 4.0  

Binding Order

Important:
This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist.

Binding paths are processed in the order shown in the list that appears during the build process. Each type of network component is identified by the following icon:

To change the binding order

  1. In the Show bindings forlist, click the type of component that has bindings you want to move.
  2. In the Target Designer Network Settingsdialog box, click the appropriate binding.
  3. Click Enable, Disable, Move Up, or Move Down.
  4. To continue the build process, click OK.

    Note

    • You can shorten connecting time and improve performance by doing the following:
      • Move the network protocol used most to the top of the binding list.
      • Move faster protocols to the top of the binding list.
      • You can drag-and-drop a network component to change its order in the binding list.

Icon Description
Network adapter
Network protocol
Network service