Important: |
---|
This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
This structure is used for provider-specific data for use with SmsSendMessageand SmsReadMessagecalls. Supporting Global System for Mobile Communications (GSM) Wireless Control Message Protocol (WCMP) is required for compliance as an Short Message Service (SMS) bearer.
Syntax
typedef struct wcmp_provider_specific_data_tag { WCMP_PROVIDER_SPECIFIC_MESSAGE_TYPE wcmppsMessageType; WORD wParam1; WORD wParam2; WORD wParam3; SMS_ADDRESS smsaAddress; } WCMP_PROVIDER_SPECIFIC_DATA; |
Members
- wcmppsMessageType
-
The type of WCMP message.
- wParam1, wParam2, wParam3, smsaAddress
-
Use of these parameters is shown in the following table. The WCMP type and code are shown for reference only.
DwMessageType wParam1 WParam2 wParam3 smsaAddress WCMP_PORT_UNREACHABLE
Destination port of original packet
Source port of original packet
Ignored
Destination address of original packet
WCMP_MESSAGE_TOO_BIG
Destination port of original packet
Source port of original packet
Maximum message size in bytes
Destination address of original packet
WCMP_ECHO_REQUEST
Identifier
Sequence number
Ignored
Ignored
WCMP_ECHO_REPLY
Identifier
Sequence number
Ignored
Ignored
Remarks
The WDP layer sends the WCMP_MESSAGETOOBIG message if an incoming primitive exceeds its limit. However, the WDP Short Message Service (SMS) provider will also issue this WCMP message directly if a multipart message is bigger than the provider can handle.
Also note that the WDP layer, not the GSM WCMP provider, sends replies to WCMP_ECHOREQUEST messages.
Requirements
Header | sms.h |
Windows Embedded CE | Windows Embedded CE 6.0 and later |
Windows Mobile | Pocket PC 2002 and later, Smartphone 2002 and later |