Important:
This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist.
4/8/2010

Adjusts the shear of the IInkTransformfor each IInkStrokeDispobject in the IInkStrokescollection by the specified horizontal and vertical factors.

Syntax 

HRESULT Shear (
  [in] float shearX,
  [in] float shearY
);

Parameters

shearX

Specifies the horizontal factor of the shear.

shearY

Specifies the vertical factor of the shear.

Return Value

HRESULT value Description

S_OK

Success.

E_INK_EXCEPTION

An exception occurred inside the method.

Remarks

The transformation applied in this method is a pure shear only if one of the parameters is 0. Applied to a rectangle at the origin, when the shearYfactor is 0, the transformation moves the bottom edge horizontally by shearXtimes the height of the rectangle. When the shearXfactor is 0, it moves the right edge vertically by shearYtimes the width of the rectangle.

Note:
When both parameters are nonzero, the results are difficult to predict. For example, if both factors are 1, the transformation squeezes the entire plane to a single line.

Requirements

Header msinkaut.h
Windows Embedded CE Windows CE 5.0 and later
Windows Mobile Windows Mobile 6 Classic and later, Windows Mobile 6 Professional and later

See Also