 Important: |
|---|
| This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
These bit-flag constants describe different bearer modes of a call. When an application makes a call, it can request a specific bearer mode. These modes are used to select a certain quality of service for the requested connection from the underlying telephone network. Bearer modes available on a given line are a device capability of the line.
The following table shows the LINEBEARERMODE constants.
| Value | Description |
|---|---|
|
LINEBEARERMODE_ALTSPEECHDATA = 0x00000010 |
The alternate transfer of speech or unrestricted data on the same call (ISDN). |
|
LINEBEARERMODE_DATA = 0x00000008 |
The unrestricted data transfer on the call. The data rate is specified separately. |
|
LINEBEARERMODE_MULTIUSE = 0x00000004 |
The multiuse mode defined by ISDN. |
|
LINEBEARERMODE_NONCALLSIGNALING = 0x00000020 |
This corresponds to a non-call-associated signaling connection from the application to the service provider or switch. This is treated as a media stream by TAPI. |
|
LINEBEARERMODE_PASSTHROUGH = 0x00000040 |
When a call is active in LINEBEARERMODE_PASSTHROUGH, the service provider gives direct access to the attached hardware for control by the application. This mode is used primarily by applications desiring temporary direct control over asynchronous modems, accessed through the Win32 communication functions, for the purpose of configuring or using special features not otherwise supported by the service provider. TAPI version 1.4 and later. |
|
LINEBEARERMODE_RESTRICTEDDATA = 0x00000080 |
Bearer service for digital data in which only the low-order seven bits of each octet may contain user data (for example, for Switched 56kbit/s service). TAPI version 2.0 and later. |
|
LINEBEARERMODE_SPEECH = 0x00000002 |
This corresponds to G.711 speech transmission on the call. The network can use processing techniques such as analog transmission, echo cancellation, and compression/decompression. Bit integrity is not assured. Speech is not intended to support fax and modem media types. |
|
LINEBEARERMODE_VOICE = 0x00000001 |
This is a regular 3.1 kHz analog voice-grade bearer service. Bit integrity is not assured. Voice can support fax and modem media types. |
Remarks
The high-order 16 bits can be assigned for device-specific extensions. The low-order 16 bits are reserved.
Note that bearer mode and media type are different notions. The bearer mode of a call is an indication of the quality of the telephone connection as provided primarily by the network. The media type of a call is an indication of the type of information stream that is exchanged over that call. Group 3 fax or data modem are media types that use a call with a 3.1 kHz voice bearer mode.
Requirements
| Header | tapi.h |
| Windows Embedded CE | Windows CE 3.0 and later |
| Windows Mobile | Windows Mobile Version 5.0 and later |