See Also
 Important: |
|---|
| This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist. |
4/8/2010
The following XML examples can be used as templates to configure the CM_Networks Configuration Service Provider:
 Caution: |
|---|
| If the default network can satisfy the connection configuration requirements, do not modify the network. If the default network cannot satisfy the connection configuration requirements, carefully read this document before using this Configuration Service Provider to make any changes to the network. When the device processes Wireless Application Protocol (WAP) connectivity documents, network and connection mapping table entries are automatically generated. The entries are then maintained internally. If modifications are necessary, use this Configuration Service Provider to modify onlythose networks that you set. |
-
Default Settings
for CM_Networks Configuration Service Provider
-
Adding a Network
Example
-
Removing a
Network Example
Below the CM_Networks Configuration Service Provider characteristic type, replace the values for each parameter and characteristic type with values that correspond to your system.
For an example of setting the preferred connections for each metanetwork that was defined in a CM_Networks Configuration Service Provider, see CM_Planner Configuration Service Provider Examples for OMA Client Provisioning.