Important:
This is retired content. This content is outdated and is no longer being maintained. It is provided as a courtesy for individuals who are still using these technologies. This content may contain URLs that were valid when originally published, but now link to sites or pages that no longer exist.
A version of this page is also available for
4/8/2010

This message sets the current position for an up-down control.

Syntax 

UDM_SETPOS 
wParam = 0; 

lParam = (LPARAM)MAKELONG(
  (short)
nPos,0);

Parameters

wParam

Not used.

nPos

New position for the up-down control. This parameter must be in the range specified by the upper and lower limits for the control.

Return Value

The previous position indicates success.

Requirements

Header commctrl.h
Windows Embedded CE Windows CE 1.0 and later
Windows Mobile Windows Mobile Version 5.0 and later

See Also

Reference

UDM_GETPOS