If there are problems in starting R-Studio and while working with it, you may use
switches to avoid them.
The following switches are available:
-all_drives
|
Forces
R-Studio to
show all logical disks in the system. Normally R-Studio shows only
local disks in the system. Some storage devices may pretend that
they are not local disks.
|
-debug
|
Includes additional
debug information. When this switch is used, an additional
command Create FS Snapshot
on the shortcut menu appears for an object
with a file system. An FS Snapshot contains system data for the
file system only (file descriptions without file contents). If a
problem appears, this snapshot can be sent to R-Studio technical
support to identify the problem. This switch greatly slows
R-Studio.
You may also turn this mode on by selecting Debug Mode on
the Settings dialog box.
|
-flush
|
Flushes the log file
after each write to log operations. This switch is helpful
when R-Studio locks and its log file remains in memory cache
unwritten to a disk. This switch greatly slows R-Studio.
|
-log <filename>
|
Started with this
switch, R-Studio writes its log into the specified file. If
R-Studio locks and its log file remains in memory cache
unwritten to a disk, use the -flush switch.
|
-mem <size in MB>
|
Sets memory usage
limit in MB for R-Studio
to reconstruct the file tree. When it
exceeds the limit, a message appears. You may temporally stop file listing
and browse through found files. Then you can resume file listing.
You also may skip this file section and continue file listing.
Example: -mem 400
- sets the limit to 400 MB.
|
-no_ide_ext
|
Turns off the inquiry
about extended information on HDDs in Wind9x/ME. This switch may be
helpful if R-Studio
returns information about HDDs incorrectly
(detects HDD geometry incorrectly).
|
-no_int13
|
Turns off the disc
access through Int13 in Wind9x/ME. This switch may be helpful if
the system operates incorrectly (detects HDD geometry incorrectly
or lock the system).
|
-no_ios
|
Turns off the
Wind9x/ME protected-mode I/O system. This switch may be helpful if
this system operates incorrectly (detects HDD geometry incorrectly
or lock the system).
|
-reset
|
R-Studio
resets an HDD controller each time it reads
a bad sector. This switch may be helpful if the controller locks
after it attempts to read a bad sector, or returns incorrect
data.
|
-safe
|
Disables automatic
partition search on a hard drive, file system recognition on
partitions, and other potentially problematic operations. In this
mode, it is necessary to use Find
partition command from the hard
drive shortcut menu to manually find a partition.
|
If an unrecognized problem appears, start R-Studio with the -debug and -log <filename> switches, and
send the log and screenshot of the R-Studio main panel to the R-Studio technical support:
R-Studio Technical Support
Team is available 24 hours a day, seven days a week, and
has an average response time less than 4 hours.
|