Pager Action
How to get hereUse this dialog to configure a pager action.
- Name. Enter an identifying name for this pager action.
- Description. Enter a short description of the action. This is displayed along with the Names in the Action Library.
- Terminal number. Enter the pager number to dial. Your service provider can provide you with this number.
- Terminal password. If required, enter the pager password here. This is a password that is required to log in to some paging services.
- Modem
Setup. Select either Primary, or one of the Alternate setups.
- Click Port
Settings to further define your selection. Modem Setup is
used specifically to support different service providers in case
you use more than one provider for sending your pager
notifications. There could also be times you want to change your
settings to meet a specific service provider's requirements for a
specific notification (for example: a lower baud rate). To do this,
you can set up an alternate Modem Setup and associate this to the
notification instead of using your Primary setting.
Note: Changing the Port Settings for the desired Modem Setup will affect ALL uses of that setting.
- Click Port
Settings to further define your selection. Modem Setup is
used specifically to support different service providers in case
you use more than one provider for sending your pager
notifications. There could also be times you want to change your
settings to meet a specific service provider's requirements for a
specific notification (for example: a lower baud rate). To do this,
you can set up an alternate Modem Setup and associate this to the
notification instead of using your Primary setting.
- Protocol. Select the type of protocol used by your pager service.
- Pager ID. Enter the pager identification number.
- Message. Enter a text message plus any of the percent variable codes used to deliver WhatsUp Gold information with the page.