NetBackup status code: 200

Message: scheduler found no backups due to run

Explanation: When the NetBackup scheduler process (nbpem) checked the policy and the schedule configuration, it did not find any clients to back up.

This error may be due to the following:

No backup time windows are open (applies only to full and to incremental schedules).
Policies are set to inactive.
The clients were recently backed up and are not due for another backup (based on Frequency setting for the schedules).
Policies do not have any clients.

Recommended Action: Usually, this message can be considered informational and does not indicate a problem. However, if you suspect a problem, do the following:

Examine the NetBackup All Log Entries report for any messages in addition to the one that indicates the scheduler found nothing to do.
Examine the policy configuration for all policies or the specific policy in question to determine if any of the reasons in the Explanation section apply.
For additional information, check the All Log Entries report. For detailed troubleshooting information, increase the logging level for the diagnostic and debug logs for nbpem, nbjm, and nbrb (use the vxlogcfg command).

See "Configuring and using unified logging" in the Troubleshooting Guide.

Retry the operation and check the resulting logs.