EVSVR commands

Table: EVSVR commands lists the commands that you can type at the EVSVR> prompt.

Table: EVSVR commands

Command

Effect

edit

Opens the EVSVR Operations dialog box so that you can edit the currently loaded operation file or create a new one.

See Creating an EVSVR operation file.

load [file]

Loads an operation file. If you do not specify a file, EVSVR prompts you to select one. You must load an operation file before you can run it.

If an operation file is already loaded, EVSVR unloads it and loads the one that you specify.

unload

Unloads the current operation file without performing any other actions.

start

Starts the execution of the current operation file.

stop

Stops the execution of the current operation file. EVSVR completes any actions that it is performing before it stops, and it generates a report file for the performed actions.

pause

Pauses the execution of the current operation file.

resume

Resumes the execution of the current operation file.

restart

Stops the execution of the current operation file and then starts it again.

status

Displays the current status of EVSVR, including its application state.

cls

Clears the EVSVR window.

exit or quit

Quits EVSVR.

interactive

Runs EVSVR in interactive mode. This mode lets you perform a number of specialized activities, including the following:

  • Retrieving the saveset and associated SIS parts of a specified archived item.

  • Retrieving a specified SIS part.

  • Extracting multiple savesets from an EMC Centera data blob.

  • Listing the locations where Enterprise Vault has stored all the parts of a specified saveset.

help or ?

Displays on-screen Help about the EVSVR commands.

More Information

Running EVSVR in interactive mode