Adding the VVR components for replication

This section provides information on configuring the VVR components for replication. You can obtain more information on how to perform these steps from the Veritas Storage Foundation and High Availability Solutions Guide.

To add the VVR components for replication

  1. Create a replicator log volume at each site.

  2. Set up the replicated data sets for VVR on the hosts for the primary and secondary sites. Note that the Setup Replicated Data Set wizard lets you configure replicated data sets for both sites.

  3. Create the VVR RVG service group.

    You must run the Volume Replicator Agent Configuration wizard from the system that contains the application service group.