You have chosen to place
the new partition on an EMC Centera device. Click if you want to go back to select a
different storage device for the partition.
After you have created the
new partition, you can edit its properties to specify the details
of a replica Centera. Enterprise Vault can then use the replica
Centera if the local Centera is unavailable.
To enter the address for each Centera access
node
-
Click .
-
Enter the IP address or DNS
name of the first access node.
-
If your Centera access node
has been set up to use a non-standard port, enter the port number
to use.
-
Click .
Note that you can click an
address to select it and then do any of the following:
-
Click to check
that Enterprise Vault can connect to that Centera access node. The
test results also show the Centera compliance mode, which is one of
the following: 'Basic','Governance', 'CompliancePlus'.
-
Click to
change the details of that address.
-
Click to
remove that address from the list.
When you have entered all
the addresses, click to
continue.
