Installation Overview and Prerequisites for the HP NNM Adapter
The steps required to install the HP NNM Adapter software
are:
Check that all prerequisites specified below are met.
Configure the web server on the NNM for Windows system.
Install the HP NNM Adapter on the HPOM and NNM systems.
Prerequisites for the HP NNM Adapter
Before installing the HP NNM Adapter, make sure that the
following prerequisites are met.
HP Network Node Manager for Windows is installed and
configured, including the installation of the NNM Web
Interface.
HPOM for Windows is installed and configured.
The interactive user (the person who installs the HP NNM
Adapter) must have administrative rights on both HPOM management
server and NNM server.
The HP NNM Adapter fully supports only configurations where the
HPOM management server, NNM server, and managed nodes belong to the
same DNS domain. If a node belongs to a different DNS domain than
the HPOM management server and HP NNM server, it might not be
recognized as an NNM node and would not be added to the HP NNM
Managed Nodes node group. If such a node is added using NNM
discovery, this problem does not arise, even if the node belongs to
a different DNS domain.
Installation of both NNM and HPOM for Windows on the same
computer is supported, but not recommended.
20 MB disk space on the HPOM for Windows management server to
install components necessary for the integration.
20 MB disk space on the NNM server to install components
necessary for the integration.
NOTE:
The HP NNM Adapter is not supported with NNM running on a domain
controller. The adapter attempts to add a user, which is not
possible on a domain controller.