Configure time reoccurrence

Use the Time Reoccurrence dialog box to specify any multiple intervals during which auto-discovery should run. You can configure the task to run around the clock or at particular specified hours. You can specify multiple intervals for tasks that are scheduled to run Daily, Weekly, Monthly, and Once.

To set multiple time intervals

1. Click Times in the Schedule tab of the Service Auto-Discovery dialog box to open the Time Reoccurrence dialog box. By default, all the intervals are selected, which means that the command runs every hour.
2. To specify the minute of the specified hour when the command should be run, click in one of the intervals in the On specified minute display. You can select only one minute during the hour. A blue bar indicates your choice.
3. Select Clear all to clear the On specified hours default settings.
4. To set one or more hours for the task to be run, click in one or more hour intervals or drag the cursor over multiple intervals. A blue bar indicates your choice. Click Set all to select all the hours.
5. To delete one or more hourly settings, click in the interval or timeline. Click Clear All to delete all the settings.
6. Click Cancel to close this dialog box without saving your changes.
7. Click OK to save your changes and close this dialog box.