Blade commands

Blade commands

Blade commands enable you to view and modify the values on a p-Class server. These values are available at /system1/map1/blade1.

Targets

You can access the following subcomponents of the blade:

Target	Description
/map1/blade1/diagport	Displays and modifies the front diagnostic port settings.
/map1/blade1/rack	Displays and modifies the blade rack settings.
/map1/blade1/rack1/enclosure1	Displays and modifies the blade enclosure settings.

Properties

Property	Access	Description
`bay_name`	Read	Displays and modifies the blade bay name.
`bay_number`	Read	Displays the blade bay number.
`facility_power`	Read	Displays and modifies if the blade 48 V power is provided by the facility.
`auto_power`	Read	Displays and modifies if the blade is enabled to automatically power up.
`log_alerts`	Read/write	Displays and modifies if rack alert logging is enabled.
`autoselect`	Read/write	Displays and modifies the diagnostic port autoselect setting.
`speed`	Read/write	Displays and modifies the diagnostic port speed setting.
`fullduplex`	Read/write	Displays and modifies if the diagnostic port supports full-duplex or half-duplex mode.
`ipaddress`	Read/write	Displays and modifies the IP address for the diagnostic port.
`mask`	Read/write	Displays and modifies the subnet mask for the diagnostic port.
`rack_name`	Read/write	Displays and modifies the rack name.
`rack_sn`	Read	Displays the rack serial number.
`encl_name`	Read/write	Displays and modifies the enclosure name.
`ser`	Read	Displays the enclosure serial number.
`encl_type`	Read	Displays the enclosure type.

Examples

set /map1/blade1/bay_name=BayOne—Sets the blade bay name to BayOne.
show /map1/blade1/diagport1/ipaddress—Displays the IP address of the front diagnostic port.
show /map1/blade1/rack1/enclosure1(N)/encl_type—Displays the enclosure type for blade enclosure N.