Previous Topic

Next Topic

Reboot section

The reboot section of the Select Items to be Installed screen enables you to specify preferred reboot behavior.

Reboot section

To instruct the system to reboot after updates are installed:

  1. Click Reboot System After Installation.
  2. Click Always or If Needed.

If Always is selected, then the system will always be rebooted unless there is a component installation failure. If If Needed is selected, then the system will be rebooted if needed by at least one component unless there is a component installation failure.

To change the delay before reboot or the reboot message, click Reboot Options. The Set Reboot Options screen appears.

Set Reboot Options

NOTE: In Linux, the Reboot Delay time is automatically converted from seconds to minutes. Any value under a full minute, 59 seconds or less, will be rounded to the next minute for Linux.

Make any changes, and click OK.