Sample custom input script

The sample script in this section gives all possible values for each option.

• If an option is shown in bold type, you must enter a value for that option when writing your own script.
• If a value is shown in bold type, ACU uses that value as a default setting when creating new logical drives.

You can use this script as a template for your own script. The Control category has the following options:

• Action mode
• Method mode

  Action = Configure|Reconfigure

  Method = Custom|Auto ; COMMENT: ACU cannot create a RAID 50 or RAID 60 configuration in Auto mode. You must create such configurations manually using the Custom setting.

  Controller = All | First | Slot [N][:N] | WWN [N] | SerialNumber [N] | IOCabinet [N],IOBay [N],IOChassis [N],Slot [N],Cabinet [N],Cell [N]

  ClearConfigurationWithDataLoss = Yes|No ; COMMENT: This option is now deprecated.

  LicenseKey = XXXXX-XXXXX-XXXXX-XXXXX-XXXXX

  DeleteLicenseKey = XXXXX-XXXXX-XXXXX-XXXXX-XXXXX | * ; COMMENT: * is a wild card that enables you to delete all license keys on the specified controller.

  RAIDArrayID = "XXXXXXXXXXXXXXXXXXXX"

  ReadCache = 0|10|20|25|30|40|50|60|70|75|80|90|100

  WriteCache = 0|10|20|25|30|40|50|60|70|75|80|90|100

  RebuildPriority = Low|Medium|High

  ExpandPriority = Low|Medium|High

  SurfaceScanDelay = N

  SSPState = Enable|Disable

  PreferredPathMode = Auto|Manual

  ; COMMENT: the following five entries are used to optimize the controller performance for video

  MNPDelay = 0|1|2|...|60 ; units are minutes, zero indicates disabled

  IRPEnable = Yes|No

  DPOEnable = Yes|No

  ElevatorSortEnable = Yes|No

  QueueDepth = 2|4|8|16|32|Auto

  Array = A|B|C|D|E|F|G|...Z|a|b|c|d|e|f

  OnlineSpare = None | N | Port:ID,Port:ID... | Box:Bay,Box:Bay... | Port:Box:Bay,Port:Box:Bay,... ; COMMENT: These values are available only in Custom method mode. In Auto method mode, the choices are Yes|No.

  Drive = * | N | Port:ID,Port:ID... | Box:Bay,Box:Bay... | Port:Box:Bay,Port:Box:Bay,...

  DriveType = SCSI | SAS | SATA

  LogicalDrive = 1|2|3|...32

  RAID = 0|1|5|50|6|60|adg|auto ; COMMENT: RAID 6 and 60 are only available when SAAP is installed and the license key registered

  ParityGroups = 2|N ; COMMENT: Necessary only for RAID 50 or 60. N > 2

  Size = [N]|Max

  Sectors = 32|63

  StripeSize = 8|16|32|64|128|256

  ArrayAccelerator = Enable|Disable

  LogicalDriveSSPState = Enable|Disable

  SSPAdaptersWithAccess = [N],[N]...|None

  PreferredPath = 1|2

  HBA_WW_ID = WWN

  ConnectionName = UserDefinedName

  HostMode = Default | Windows | Windows(degrade | openVMS | Tru64 | Linux | Solaris | Netware | HP | Windows Sp2 ; COMMENT: The Windows(degrade value must be entered as written.