WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment, remove the power cord
to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC
power is removed.
IMPORTANT: If installing a hot-plug device, it is
not necessary to power down the server.
Back up the server data.
Shut down the operating system as directed
by the operating system documentation.
If the server is installed in a rack, press
the UID LED button on the
front panel (1). Blue LEDs illuminate on the front and rear
panels of the server.
Press the Power On/Standby button to place
the server in standby mode (2). When the server activates standby
power mode, the system power LED changes to amber.
If the server is installed in a rack, locate
the server by identifying the illuminated rear UID LED button.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment, remove the power cord
to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC
power is removed.
IMPORTANT: If installing a hot-plug device, it is
not necessary to power down the server.