|
|
|
The auto-configuration process automatically runs when you boot the server for the first time. During the power-up sequence, the system ROM automatically configures the entire system without needing any intervention. During this process, the ORCA utility, in most cases, automatically configures the array to a default setting based on the number of drives connected to the server.
NOTE: The server may not support all the following
examples.
NOTE: If the boot drive is not empty or has been
written to in the past, ORCA does not automatically configure the
array. You must run ORCA to configure the array settings.
|
Drives installed |
Drives used |
RAID level |
|---|---|---|
|
1 |
1 |
RAID 0 |
|
2 |
2 |
RAID 1 |
|
3, 4, 5, or 6 |
3, 4, 5, or 6 |
RAID 5 |
|
More than 6 |
0 |
None |
To change any ORCA default settings and override the auto-configuration process, press the F8 key when prompted.
By default, the auto-configuration process configures the system for the English language. To change any default settings in the auto-configuration process (such as the settings for language, operating system, and primary boot controller), execute RBSU by pressing the F9 key when prompted. After the settings are selected, exit RBSU and allow the server to reboot automatically.
For more information, refer to the HP ROM-Based Setup Utility User Guide on the Documentation CD or the HP website.