1747-Slot z Drive Array - Unsupported Array Configuration Detected...

...Followed by one of many possible reasons, including the following:

* More logical drives are configured than this controller can support when the memory module is detached.

* One or more logical drives are configured in positions that this controller does not support when the memory module is detached.

* One or more logical drives are configured for RAID fault tolerance level(s) that are not supported when the memory module is detached.

* Configuration information indicates one or more hard drives are located in drive bays that are inaccessible when the memory module is detached.

* Capacity Expansion operations are pending but cannot continue because the Array Accelerator memory module has been detached.

* Drive Erase operations are pending but cannot be completed because the Array Accelerator memory module has been detached.

ALL logical drives have been disabled. To avoid data loss, re-attach drives to original controller or upgrade controller. To discard all data and create a new configuration, run the Array Configuration Utility.

Audible Beeps: None

Possible Causes:

• The Array Accelerator memory module was removed or is defective.
• The drives were moved to a controller that does not have an Array Accelerator memory module attached.

Action: Attach an Array Accelerator memory module to this controller, or move the drives back to the original controller. If Capacity Expansion operations were pending, be sure that the original Array Accelerator module is attached.