1785-Slot X Drive Array Not Configured...

(followed by one of the following):

...(1) Run Array Configuration Utility

(2) No drives detected

(3) Drive positions appear to have changed – Run Drive Array Advanced Diagnostics if previous positions are unknown. Then turn system power OFF and move drives to their original positions.

(4) Configuration information indicates drive positions beyond the capability of this controller. This may be due to drive movement from a controller that supports more drives than the current controller.

(5) Configuration information indicates drives were configured on a controller with a newer firmware version.

Audible Beeps: None

Possible Cause: Drive array configuration not detected.

Action:

• Run ACU.
• Power down the system and check SCSI cable connections to be sure the drives are connected properly.
• Run ADU if previous positions are unknown. Then, turn the system power off and move the drives to their original positions.
• To avoid data loss, update the controller firmware to the same or later version on the original controller.