...The following SCSI
drive(s) need Automatic Data Recovery: SCSI Port Y: SCSI
ID Z
Select F1 to retry
Automatic Data Recovery to drive. Select F2 to continue
without starting Automatic Data Recovery.
Audible
Beeps: None
Possible
Cause: System is in Interim Data Recovery Mode and a
failed or replacement drive has not yet been rebuilt. This message
is displayed if the F2 key
was pressed during a previous boot or if the F1 key was pressed during a previous boot
and the system rebooted before the rebuild of the drive
completed.
Action:
Perform one of the suggested actions:
Press the F1 key to retry Automatic Data Recovery
to the drive. Data will be automatically restored to drive
X when a failed drive has been replaced,
or to the original drive if it is working again without
errors.
Press the F2 key to continue without recovery of
data to the drive. The failed drive will not be rebuilt and the
system will continue to operate in a failed state of Interim Data
Recovery Mode.
If drive recovery is not successful, run ADU
for more information.
If the replacement drive failed, replace
with another drive.
If the rebuild was aborted due to a read
error from another physical drive in the array, back up all
readable data on the array, run ADU, and then restore the
data.
